How To Install A New Bathtub Faucet – Introduction We’ll show you how to replace your old-style bathroom drain with a low-maintenance lift-and-turn drain. After removing the old stopper, it is easy to install the new one. So ditch the lever-style drain that catches all the hair in your bathroom and replace it with a new one that doesn’t have complicated connections.
Purchase a new lift and swivel stopper to replace your old lever-style drain. When the stopper on a lever-style tub drain won’t open because the connector is damaged or stuck, replace it with a more simple lift-and-turn style tub drain.
How To Install A New Bathtub Faucet
The drain connection on the lever attracts dirt and hair like a magnet and must be cleaned regularly to keep the drain working properly. A lift and diverter drain does not have complicated connections for digging and cleaning — almost everything is held in the drain net. To get started on your bathroom drain replacement project, purchase a bathroom stopper replacement kit at hardware stores and home centers.
Bathtub Installation & Replacement Costs In 2024
This photo shows how to remove the excess plate, stopper housing and linkage. The link may stick and be stubborn to remove. Grasp it and pull hard until it comes out. After the link is removed, screw in a new overhang plate. Unscrew the overflow plate and remove the upper connection from the overflow tube. Remove the drain plug and remove the lower connection as well. Pull both parts of the link firmly as you remove them, as they may bind inside the excess tube.
The hardest part of how to remove a bathtub drain is removing the tub drain plug housing, but after that it’s all downhill. Remove the old plug housing as shown here. If you’re having trouble getting it out, try heating it up with a hair dryer on high. Heat can help soften old plumber’s putty. The casing of an old bathtub drain plug can also be cut out with a reciprocating saw and a metal knife, but be very careful as it is easy to cut and damage the tub. Cut a 1/4-inch wide and deep slot in the old cork body with a small hacksaw. Check the progress frequently to avoid going into the bathroom. 3/4-in. insert a cold chisel into the cut hole and hammer counterclockwise to release the plug housing (be careful with the hammer to avoid scratching the enameled tub). Unscrew completely and remove the plug housing.
Slide in the new gasket. Next, slide a pencil-sized bead of plumber’s putty and press it under the rim of the new plug housing. Close the 8-inch jaws. insert the clamp into the mesh of the stopper body and insert it into the drain pipe.
All that’s left on how to unclog a bathroom drain is to install a new tub drain plug housing and stopper. Slide the new rubber gasket over the drain pipe under the tub and fit the new drain flange with plumber’s putty as shown here.
How Much Does It Cost To Install Or Replace A Bathtub?
If the new threads are different than the old, use the supplied bushing. Screw the stopper into the cork body and congratulate yourself on a job well done. If you have other bathroom problems, learn how to repair a bathroom faucet.
We no longer support IE (Internet Explorer) as we strive to provide site experiences for browsers that support new web standards and security practices.